Robotic cleaners are a hugely useful addition to any pool, but like anything else they need a little care and attention to keep them in top working condition. This article will look at some of the things you should be doing to maintain your robotic cleaner so it’s running at full speed and picking up all the debris from your swimming pool.

While many older suction cleaners were left in the pool permanently, modern robotic cleaners can be removed after each use. When they aren’t being used, it is a good idea to remove them from the water, clean them out and give them a gentle rinse with fresh water. This will help to ensure that any debris in the filters doesn’t clog the robot and cause it not to function properly.

If you’re going to be removing your robotic cleaner from the water, it’s also a good idea to empty the filter bag or vacuum canister of any debris that may have been pulled in during cleaning. This will prevent the robot from overworking and potentially overheating.

Keeping your robotic cleaner in good condition will help it to perform at its best and extend its life. A robotic cleaner will need to be hosed down regularly to remove any build-up of dirt or algae from its brushes, wheels and tracks. Depending on the type of robot you have, this may involve removing the cleaner from the pool and opening its casing to access its interior. In some cases, you may be able to simply hose the robot down from the outside, but you’ll want to make sure you get into all of its corners and under the scrubbers to remove any dirt or dust.

A common problem that can occur is when the robot stops moving across your pool floor, or even worse, it may turn over during a cleaning cycle. In most instances, this will be caused by a lack of connection to power or a tangled cable that is pulling on the cleaner and preventing it from moving freely. Always check the cord for damage or a tangle, and ensure that there is sufficient slack in it to allow the robot to move freely.

You should also check your robot’s motor to make sure it is still functioning correctly. If it’s not, then it could be due to a dirty or damaged brush, improper floatation or poor suction. These issues are usually fairly easy to fix, so you should be able to solve them with minimal trouble.

Finally, it’s a good idea to consult your robotic cleaner’s manual when troubleshooting issues. This will provide you with a step-by-step process that can be followed to get your cleaner back up and running in no time at all. Remember, though that if your robot is showing signs of wear and tear or is not performing as it should be, then it’s probably time to invest in a new one.